Nordson LA 404 - Remote Input Plug

LA 404 Pattern Control System
21
Part 1037527B
! 2005 Nordson Corporation
Manual 66-LA404-MA-01
Remote Input Plug
The remote input plug provided in the ship-with kit connects to the Remote
Input connector, it is typically used to prevent the pattern controller from
dispensing adhesive until a melter or parent machine is ready as shown in
Figure 5.
To e na b le th e p a tt e rn co n tr o ll e r t o b eg i n d is p en s in g a d he s iv e :
Connect the 24 VDC (Remote Input plug, pin 1) to the enable input
(Remote Input plug, pin 7) using an electrically isolated contact. Refer
to the Remote Input pin drawing under I/O Connector Pin Layout.
To b yp a ss (o r t o s e t t o I NA C TI V E) th e r e mo t e e na b le fu n ct i on , r e fe r t o
System Settings 3.
6640036A
Melter
LA404 Pattern Controller
1
7
Remote Input
Connectors
Ready Contact
Figure 5 Connecting the Pattern Controller to the Melter for Pattern Generation