15OPERATING INSTRUCTIONSPULSE PRO User Manual
To disconnect connectors from the Junction Box or the PULSE PRO Control Unit, push the
button on the top of the NormaTec Hose Connector/Attachment Connectors while pulling away
from the Junction Box/PULSE PRO Control Unit.
TO TURN OFF THE DEVICE
To turn o the system, press the Power Button and confirm that the green power LED is shut o.
It is recommended that you leave the Control Unit plugged into the wall to charge.
HOW TO USE ZONE BOOST
During your session, you can increase the intensity of a single zone with the Zone Boost feature. Zone
Boost will add an extra 60 seconds of massage time, as well as 10 mmHg increased pressure, in the
zone that is selected.
To turn Zone Boost on or o, tap the Zone Boost Button on the Home Screen. An image of the
attachment will appear on the screen. To turn Zone Boost on, tap on the zone you wish to select. To
turn Zone Boost o, tap once on the selected zone. When complete, tap on the Back Button to return
to the Home Screen.
To determine which zone is active, refer to attachment graphic on the Home Screen—the
selected zone will flash the Zone Boost Icon.
When you power o the machine, the Zone Boost feature will also be turned o.
CUSTOM MODE
When entering Custom Mode, the pressure is displayed to the left of each zone and the time is
displayed to the right of each zone. Starting with Zone 1, tap on the pressure or time for any zone to
adjust that zone’s settings. Use the up and down arrows to adjust the pressure and time, and tap the
Back Button to return to the Custom Screen.
Starting from the foot, hand, or thigh (depending on the attachment selected), each zone can
not be set more than 10 mmHg higher than the previous zone.
When Custom Mode is enabled both the Mode Button and Intensity Button on the Home
Screen will display custom.
You can change the selected attachment from this screen by tapping once on the Change
Attachment Button at the bottom of the screen.
To Next Page
Loading...
Need help?
General
