Nortek IEI 232e Standalone User Manual

5. Testing the Keypad
After installing the keypad, IEI recommends that you perform the
keypad self-test once a year, to ensure that the keypad works prop-
erly.
1. To perform the self-test, with the unit powered up, press the
following keys on the keypad:
7890#123456*
• If all 12 keypresses are accepted, the keypad enters self-test
mode.
• The LEDs alternate green, yellow, and red followed by the
sounder beeping three times.
2. Verify that the master code works correctly. (The master code
accesses program mode and activates the main relay to verify
that the locking device is working.)
The default master code is 1234.
IEI 232e Standalone Installation/Programming Manual
14 Document # 6054004, Rev. 2.1

Nortek IEI 232e Standalone Specifications

General

Brand	Nortek
Model	IEI 232e Standalone
Category	Keypad
Language	English