Nortek YAP1F - Page 23

3DJH
User’s Manual of Remote Controller
In unit on status, press ▲ button to increase set temperature and press ▼ button
to decrease setting temperature.
Note: Under auto mode, manual adjustment of temperature is not needed.
（
3
）
Adjusting fan speed
In unit on status, press FAN button to adjust fan speed in following sequence:
Note: Under dry mode, fan speed is low and can not be adjusted.
（
4
）
Setting swing function
In unit on status, press SWING button to set swing status in following
sequence:
（
5
）
Setting turbo function
1
）
Under cool or heat mode, press TURBO button to set turbo function.
2
）
When is displayed, turbo function is on.
3
）
When is not displayed, turbo function is off.
4
）
When turbo function is on, the unit operates in super high speed to achieve
quick cooling or heating. When turbo function is off, the unit operates in set
fan speed.
（
6
）
Setting light function
The light on the receiver light board will display present operation status. If you
want to turn off the light, please press LIGHT button. Press this button again to turn on
the light.
（
7
）
Viewing ambient temperature
1
）
In unit on status, receiver light board or wired controller is defaulted to display
setting temperature. Press TEMP button to view indoor or outdoor ambient
temperature.
2
）
is displayed, it means the displayed temperature is indoor ambient
temperature.
3
）
When is displayed, it means the displayed temperature is outdoor