Nortel 2332 - Installing a Series 2332 Access Point; Installation Hardware and Tools

Installing and connecting a Series 2332 Access Point 35
Nortel WLAN Series 2332 Access Point Installation Guide
Mounting a Series 2332 access point on a solid surface requires using a Cat-5e cable that does not have strain relief. For
installation on all other surfaces, you can use the Cat-5e cable with or without strain relief.
(For more information about cables, see “Cable ports” on page 27.)
Installing a Series 2332 access point
To install a Series 2332 access point, use one of the procedures in this section.
Installation hardware and tools
Table 3 lists the mounting hardware and tools required for each type of installation.
Table 2: 10/100 Ethernet Straight-Through Pin Signals
WSS Other Device
Pin Function Pin Function
1RD+1TD+
2RD-2TD-
3TD+3RD+
4PoE+4PoE+
5PoE+5PoE+
6TD-6RD-
7PoE-7PoE-
8PoE-8PoE-