Filters and QoS Configuration for ERS 5500
Technical Configuration Guide v2.0 NN48500-559
___________________________________________________________________________________________________________________________
Nortel Confidential Information Copyright © 2008 Nortel Networks. All Rights Reserved.
External Distribution
42
Example:
The following example creates a meter with a CIR of 10 Mbps, burst rate of 20 Mbps for 13 msec
with an in profile action of Silver Service and an out profile action of drop traffic.
• ERS5500-48T(config)#qos meter 1 name meter_one committed-rate 10000 max-
burst-rate 20000 max-burst-duration 13 in-profile-action 4 out-profile-action 1
11.4 Add a New Policy
a) To assign a Classifier to a new Policy without a meter, enter the following command:
• ERS5500-48T(config)#qos policy <1-64000> name <name> if-group <if-group name>
clfr-type <block|classifier> clfr-id <1-64000> in-profile-action <1-64000> non-match-
action <1-64000> precedence <3-10**> track-statistics <individual/aggregate>
NOTE: Instead of ‘clfr-id’ you can also enter the classifier or classifier-block name by using ‘clfr-
name’.
b) To assign a Classifier to a new Policy with a meter, enter the following command:
• ERS5500-48T(config)# qos policy <1-64000> name <name> if-group <if-group
name> clfr-type <block|classifier> classifier clfr-id <1-64000> meter <1-64000>
non-match-action <1-64000> precedence <3-10**> track-statistics
<individual/aggregate>
Example:
The following adds classifier block 1 to policy 1 with an in profile action of drop if matched and out
profile action of Standard Service if not matched.
• ERS5500-48T(config)#qos policy 1 name policy_one if-group role_one clfr-type
block clfr-id 1 in-profile-action 1 non-match-action 2 precedence 10
To add track individual statistics for each classifier, use the following command:
• ERS5500-48T(config)#qos policy 1 name policy_one if-group role_one clfr-type
block clfr-id 1 in-profile-action 1 non-match-action 2 precedence 10 track-statistics
individual
To Next Page