DAP management 201
5 Enter the new RPN.
The RPN must be a hexadecimal two-digit number in the range
000 to 00F.
6 Click OK.
Wait until DAP restarts and starts working.
--End--
Restarting a DAP
Restart a DAP. This can be required if you are upgrading software, or if
a DAP is not functioning properly.
Procedure 114
Restarting a DAP
Step Action
1 Open Internet Explorer and enter the following URL in the
address field: localhost/cds.
The DAP manager IP DECT page appears.
2 Click Access points.
The DECT Access Points page appears.
3 Select the DAP to restart.
4 Click Reboot.
The DAP restarts. It takes several minutes for the DAP to begin
working again after it restarts.
ATTENTION
If you use Reboot to restart a DAP, information about types and
software versions of subscribed handsets is lost, and is restored after
several hours. You can restore this information immediately using
either of the following methods:
• Turn the handsets subscribed to the restarted DAP off, and
then on again.
• Restart all DAPs using the option "Reboot all" in DAP
Manager. For information, see “Restart all DAPs” (page
201).
--End--
Restart all DAPs
Restart all the DAPs in a system. This can be required if you are
upgrading software, or if the DAPs are not functioning properly.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
.
To Next Page
Loading...
Need help?
General
