Troubleshooting 241
Call server
1.
Digit Manipulation Block A (no digits to delete). For more
information, see Procedure 64 “Adding digit manipulation block” (page
129).
2. Route List Block B is configured for Route Y and DMI A. For more
information, see Procedure 65 “Adding route list block” (page 129).
3. UDP--Location code (RLI B is entered, FLEN is equal to sum of
the digits in LOC and DN). For more information, see Procedure 66
“Adding location code (for UDP)” (page 130).
4. CDP--Trunk Steering code (RLI B is entered, FLEN is equal to sum
of the digits in TSC and DN). For more information, see Procedure 67
“Adding Trunk Steering Code (CDP)” (page 130).
5.
PCA is on and UEXT is configured as follows:
—
UXTY SIPN
—
KEY 0 SCR <DN>
— KEY 1 HOT P <number of digits> <AC><LOC><DN> (if UDP)
OR
KEY 1 HOT P <number of digits> <TSC><DN> (if CDP)
where DN is the local number of the DECT handset subscribed
in the DAP Manager. For more information, see “Call server
configuration” (page 140).
• SIP GW setting--Primary Proxy or Redirect (TLAN) IP address =
NRS IP address
For more information, see Procedure 68 “Configuring the signaling
server” (page 130).
•
Signaling Server--select the Enable SIP Proxy / Redirect Server
check box when SIP Gateway and Redirect Server (NRS) are
co-resident Signaling Server – SIP Domain name = domain name
configured in IP DECT Configurator.
For more information, see Procedure 69 “Configuring SIP properties”
(page 132).
• Service domain name is the same as SIP domain, configured on the
signaling server and the IP DECT Configurator.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
.
To Next Page
Loading...
Need help?
General
