Nova Max PLUS User Manual

31
Running a ß-Ketone Test
1. Insert a ß-ketone test strip into the monitor. Ketone is a green
strip. If monitor was o, the screen displays all segments for 2
seconds.
NOTE: If the strip is removed before you start the test, the screen
goes blank.
2. After 3 seconds, the blinking blood drop symbol appears with
“Ket” displaying.
NOTE: If a test is not performed within 2 minutes from the insertion
of the test strip, the screen goes blank. To perform a test, take out
then replace the test strip starting from Step 1.
3. Wash hands with soap and warm water then dry thoroughly. Or
use alcohol pads to clean area; dry thoroughly after cleaning.
NOTE: Cleaning of the puncture site is important.
4. Holding hand downward, massage nger with thumb toward
tip to stimulate blood ow.
Apply Blood
Drop Here
Insert this
End Into
Monitor
Nova Max Plus Monitor OG PN46171D1 EN.indd 31 9/5/12 3:22 PM

Nova Max PLUS Specifications

General

Test Time	5 seconds
HCT Range	30 - 55%
Operating Temperature	50-104°F (10-40°C)
Operating Humidity	10-90% RH
Blood Sample Size	0.5 µL
Measuring Range	20-600 mg/dL