ML0035 September 27, 2017 - 115 - Copyright 2017 Bitronics, LLC
Revision Date Chan
es B
3/15/2010 Ori
inal Issue E. DeMicco
B 4/15/2010 New web screen shots, fiber Ethernet
option, corrections
E. DeMicco
C 6/21/2010 Manual references, transducer output,
new setup map, configurable display
setup, demand screen in data view
E. DeMicco
D 2/24/2011 Secondary volts screens, default and
identity setup via front, 4-20mA
information, configurable registers/points,
health check information
E. DeMicco
E 9/27/11 Split-core CTs, phase angle
measurements, CT polarity invert,
password, primar
units
E. DeMicco
F 11/15/11 Correction to Display (4.1) Setup Menu
5.5
and Appendix A3 for screen orde
E, DeMicco
G 12/15/11 New screen shot for serial port, added
4.1.3 Display Error Messages, new
external CT drawin
E. DeMicco
H 7/13/2012 Format VT specification section, Clarified
Split core in specification section, Added
Protective Conductor terminal torque
under physical specification; Sect. 1.3
various clarifications added to
specifications; Sect. 1.5 revised with
standards; Note added to Figure 2; Sect.
3.0 revised; Figure 3 became 3A;
Figure3B added; Sect. 3.1 revised with
monitoring option for L1(+)/L2(-) power
input; Revise Sect. 3.1.1 information per
Sect. 1.3; Sect. 3.2 Added references
VA,VB, VC, VN; Sect. 3.3 Added
references IA, IB, IC and current options
for 1A(1), 5A(5), and external split core
(C).
New dimension drawing to correct error
with metric and added note on common
return for transducer output. Updated
fiber connector from MT-RJ to LC.
Added information for UL and CE
certification and standards met.
R. Fisher
E. Demicco
I 6/14/13 Added support for loss compensation;
updated information on firmware up
rade
E. DeMicco
J 11/14/13 Updated sections 1.3 – 1.5 for UL 61010
3
rd
edition chan
es
E. DeMicco
To Next Page
Loading...