To Next Page

To Previous Page

to poll the 1st IPv4 interface,

inarp -v 50series

CTRL-C stops the scan

to poll the IPv4 interface associated with 192.168.1.1, use

inarp -v -i 192.168.1.1 50series

or to poll a specific mac, use

inarp -v -i 192.168.1.1 00:D0:4F:03:00:15

Portions of inarp are

3.5.2 Indicators – Ethernet (ACT) & Serial LEDs

There are 2 LEDs on the rear panel to indicate activity is occurring on the

communication ports. These LEDs are useful in determining that there is activity

occurring on the ports. The "ACT" LED will flash to indicate there is activity on the

Ethernet port. It will also indicate that a link has been established. The Serial LED

flashes to indicate there is activity occurring for the serial port.

A troubleshooting guide is found in Appendix A2, which may be useful in establishing

Ethernet connections.

3.5.3 Firmware upgrades and saving and loading configuration files – Ethernet

service port

New versions of firmware may be released by Bitronics from time to time, either to add

new functionality or to correct errors in code that may have escaped detection prior to

commercial release. Consult the factory for detailed information pertaining to the

availability of firmware upgrades. In cases such as this, it is desirable to support a

mechanism for new firmware to be installed remotely. The ability to upgrade Firmware

is done over the Ethernet port. The M650 family utilizes a page in the Web Server

interface to upload and install new firmware.

The complete M650 configuration, which includes all user-configurable parameters,

can be saved in a single file on your computer. This allows you to save a backup of

your configuration and to restore it at a later time, as needed. This also allows you to

configure one M650 and then transfer the configuration to multiple other M650’s.

Before initiating the firmware upgrade, if you are planning to use a configuration that

has already been setup in the M650, then you should first go to the Load/Store

Settings page and click on the Get File button to save the IED configuration to your

computer (if you will be using a default configuration this step is not necessary). Use

the File Save dialog window to select the location on your computer to save the

configuration file. Once you have saved the file, it is recommended that you load the

file back to the M650 to validate that it was saved correctly. Click the Browse or

Novatech Bitronics 50 Series User Manual

Questions and Answers: