33
English
2. Faders – Impulse 25 only
Clicking the fader area of the Impulse image in the Mapping Editor window will cause the
display to change to a set of nine faders (initially Tracks 1 – 8 plus the Master fader). As
Impulse 25 has just one physical fader, it will initially be assigned to Track 1.
Using Track Up/Down (these are shifted functions of the two Octave buttons
9
) it is possible
to sequentially increment/decrement track assignment to the physical fader, thus allowing you
to build up your mix one channel at a time. See “Track Up/Down” on page 34.
As with the encoders, there are additional pages of the Mapping Editor window. These may be
accessed in the same way as described above.
3. Faders – Impulse 49 and 61
Clicking the fader area of the Impulse image in the Mapping Editor window will cause the
display to change to a set of nine faders. These represent the nine faders on Impulse.
To Next Page
Loading...
