27
Once all 8 drum pads have been set for maximum velocity calibration, press the Page Up button again for soft hit
calibration:
Hit a pad softly and view the hit velocity value. If the value does not update when you hit the pad then the threshold is
too high. Use the encoders to adjust the threshold values. Lowering the threshold will increase the sensitivity of the pad
meaning that it will respond to a softer hit.
WRItInG GLoBAL SEttInGS
To save all global settings, press the WRITE button whilst in the Global menu. Remember that global settings can be saved
regardless of whether memory protect is set to ‘ON’ or ‘OFF’.
tRAnSPoRt
The second row of buttons below the sliders can either be used as transport control, or for use within the current
template (either as Automap or Advanced mode MIDI buttons).
When lit, the buttons will be available as transport controls. This will also be indicated in the Automap HUD when in
Automap Mode.
In Advanced Mode you can edit the MIDI message the Transport Buttons send in the same way as any other control.