9
ZERo SL MkII SEtUP EXAMPLES
The ZeRO SL MkII can be used for controlling both computer music software and external hardware:
SoftWARE ContRoL
To use the ZeRO SL MkII to control your music software, connect the ZeRO SL MkII to your computer with the supplied
USB cable.
HARDWARE ContRoL
To use the ZeRO SL MkII with your MIDI hardware, you will need to power the ZeRO SL MkII with a 9 volt 1000mAmp DC
PSU - center pin positive (not supplied).
Connect a MIDI Cable (5pin DIN) from the ZeRO SL MkII MIDI Out 1 port to the MIDI In port on your hardware.
ZERo SL MkII AS A MIDI IntERfACE WItH SoftWARE AnD HARDWARE
ContRoL
Using the ZeRO SL MkII with External Hardware AND a Host Computer
You can also combine the two above set-ups so that the ZeRO SL MkII is used as a software controller and hardware
controller - transmitting MIDI data to and from computer and MIDI hardware. This will allow you to record MIDI data
to your software DAW or Sequencer, and the ZeRO SL MkII will then transmit this data to your hardware. For detailed
information on using the ZeRO SL MkII as a MIDI interface please see the routing section in the global menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
![Preview: Novation Launchpad Mini [MK3]](https://data.easymanua.ls/products/284351/200x200/novation-launchpad-mini-mk3.webp)
