OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi
13
EN
The service mode (HOLD) can be used to stop the pump when carrying out small-scale servicing work,
for example. The service mode is activated by choosing Hold
in the Settings
menu. The service
mode runs for 60 minutes by default, but it can be interrupted manually by pressing the back symbol .
SELECT PREMIUM, EXCLUSIVE ST2T
The screen view of the pool can be turned for ease of use in the inside and outside of the pool. The
screen view turns by pressing Turning the display
symbol at the right side of the status bar.
TURNING THE DISPLAY
From time to time there will appear symbol at the bottom of the screen, which indicates a timed
reminder message. Reminder messages are possible to turn off, by choosing Reminders
in the
Settings
SETTINGS
menu. The setting is changed by pressing the REMINDERS bar (Yes/No). The most common
messages and their meaning are shown in the table below.
TIMED MESSAGES
MESSAGE MEANING
Check the pH Check the pH of the water and adjust the chemicals if necessary.
Check the sanitizer Check the amount of chloride and add if necessary.
Clean the lter Clean the lter.
Test the GFCI Check that the ground fault circuit interrupter is functional.
Change the water Replace the water in the outdoor spa pool.
Clean the cover Clean the insulation cover.
Change the lter Change the lter
The temperature and time format can be changed by selecting Units
UNITS
in the Settings
SETTINGS
menu.
The temperature unit is changed by pressing the TEMP DISPLAY bar (°C/°F), and the time format by
pressing the TIME DISPLAY bar (24 HR/12 HR). To return to the main view, press the back symbol .
UNITS
To go to the technical settings, select Utilities
UTILITIES
in the Settings
SETTINGS
menu. In the technical settings you
can modify the screen time-out settings Panel
PANEL
as well as see the log information of the last 24 error
codes Faults
FAULTS
.
TECHNICAL SETTINGS
M8 EFFICIENT SMARTNESS
Energy consumption is minimized with the new M8 feature. The M8 feature automatically determines
the activation of the jets, according to the conditions and ambient temperature.
You can nd the M8 setting (On/Off) in the Settings
SETTINGS
menu by pressing the M8
M8
symbol.
To Next Page
Loading...