EasyManua.ls Logo

Novitek STANDARD - Water Care and Chemistry; Fiber Filter Maintenance; Cleaning Chemicals and Water Balance

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi
EN
WATER CARE
The water of the pool is maintained in three different ways. The water stays clean and clear by means
of the bre lter, the ozonisation system and cleaning chemicals.
FIBER FILTER
OZONIZATION SYSTEM
CLEANING CHEMICALS
The bre lter collects small debris from the water. The bre lter should be replaced for a new one
always in conjunction with a water change. The bre lter can get clogged up with calcium particles
found in hard water, as a result of which, the water ow weakens. The operating time of the bre lter
can be lengthened, and the ltration effectiveness improved, by rinsing the bre lter under owing
water 2 – 4 times a month. The ltration system of the pool is completely automatic.
Before switching the bre lter, make sure that a ltration period is not in action. If needed, turn off the
power to the pool, or switch the pool into the HOLD-mode. The instructions on how to remove the Fibre
lter are on the previous opening.
The ozonisation system removes bacteria, particles and musty odour. The system is functioning, when
air bubbles are rising out of the grey ozone jet.
The ozonisation system is completely maintenance free and does not cause any measures to be taken
by its owner. However, to ensure adequate cleaning effectiveness, the appliance should be replaced for
a new one every 3 – 4 years.
The cleaning chemicals (chlorine) keep the water disinfected, clear and clean, as well as removes
bacteria from the water. In addition to chlorine, chlorine-free active oxygen tablets or SpaBalancer
water care solution can be used in the hot tub. For more precise instructions on the dosage of the
cleaning chemicals, view the package of your chosen chemical product.
Chlorine works best, when the pH value of the water is 7,2 – 7,6. Keep track of the pH values of the pool
regularly. The use of the pool, chlorine use and rainwater that potentially winds up in the pool lower
the pH value of the water. The chemical expenditure varies depending on the municipality, since the
water pH value, as well as chalice and iron concentrations uctuate greatly.

Table of Contents

Related product manuals