Novitek STANDARD - Setting TP500 Time; TP500 Operating Modes; TP500 Service Mode

22
OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi
EN
MODES
The pool’s LED lights can be turned on by pressing the LIGHT button
5
. To turn off the lights, press the
LIGHT button
5
again. The pool’s LED lights have different colors and light modes. To change the light
mode, turn off the LED lights and immediately turn them back on. The LED lights turn off automatically
four hours after being turned on.
LED LIGHTS
In order to keep the pool water warm, the pump circulates the water through heaters. In the READY
mode, the pool maintains the set temperature and heats up the water as necessary. In the REST mode,
the pool heats up the water only during set ltration cycles. In the REST mode, the pool display may
not necessarily show the pool temperature but the text RUN | PUMP | FOR | TEMP | -- --
-- --. instead.
To change the mode, rst press the MENU button
3
repeatedly until you see MODE on the display.
Choose the desired mode by pressing the WARM button
1
or the COOL button
2
. Exit the menu by
pressing the MENU button
3
.
PLEASE NOTE! The chosen mode is shown at the bottom of the display.
To lock the pool’s control panel, rst press the MENU button
3
repeatedly until you see LOCK on the
display. After this, lock either the water temperature settings (TEMP) by pressing the WARM button
1
or the whole control panel (PANL) by pressing the MENU button
3
again. Change the setting (ON/
OFF) by pressing the WARM or COOL button
1 2
. Save your choice and exit the menu by pressing the
MENU button
3
.
To open the keylock, press the WARM button
1
while simultaneously calmly pressing the MENU
button
3
twice.
KEYLOCK
The service mode (HOLD) can be used to stop the pump when carrying out small-scale servicing work,
for example. The service mode lasts for 60 minutes. To start the service mode, rst press the MENU
button
3
repeatedly until you see HOLD on the display. After this, press the WARM button
1
. The
display now reads HOLD | ING | FOR | 0:60 (the running timer shows the remaining time for
which the pumps will be disabled).
SERVICE MODE
The time must be set immediately after the pool’s installation, as the correct time is important for the
functionality of the ltration cycles. To set the time, rst press the MENU button
3
repeatedly until
you see TIME on the display. After pressing the WARM button , you can set the time with the WARM
and COOL buttons
1 2
. Move on to the next phase by pressing the MENU button
3
.
PLEASE NOTE! If the pool loses power or the power is turned off, the time must be reset.
SETTING THE TIME
To turn the display, rst press the MENU button
3
repeatedly until you see FLIP on the display. After
this, you can turn the display with the WARM and COOL buttons
1 2
.
TURNING THE DISPLAY
STANDARD TP500