User Manual TXLD0012
P/N T2-UM-E-ENG Rev 10 Novoxel.com Page | 29
Item # Description
1.1
1.2
The Handpiece which was pre-selected in the Home screen, will be heated to
working temperature (400°C) and sterilized. When heated the icon will become
orange and blink.
The selected Handpiece shall be indicated by the red dot in the following icon:
When Handpiece temperature have reached 385°C and sterilized, the icon will
become green, and blink until treatment parameters are selected (see indents 4, 5 &
6 further below in this table).
After the treatment parameters have been selected, the Handpiece will become
active; The green icon will be displayed continuously and treatment can be
performed.
Note: The other Handpiece will remain at hibernation temperature (200°C) indicated
by an orange icon.
Preparing the Second Handpiece for Operation
Press on the hibernated Handpiece icon. The second Handpiece will be heated to
working temperature and sterilized for 1:00 minute. During the heating process, the
icon will become orange and blink.
After the sterilization process has been completed, the second Handpiece will have a
blinking green icon but without the red dot.
Switching between Handpieces
Press on the icon of the second Handpiece. The Handpiece icon will have a red dot,
as demonstrated below:
The icon will blink until treatment parameters are selected (see indents 4, 5 & 6
further below in this table). After the treatment parameters have been selected, the
Handpiece will become active; The green icon will be displayed continuously and
treatment can be performed.
To Next Page
Loading...