– 72 –
Extraction control
Switch on/lift extraction tower position
Decrease extraction speed
Increase extraction speed
Switch o/lower extraction tower position
Extraction indication
Cleaning indication for grease lter
Cleaning indication for recirculation lter (optional)
Preset extraction function
Hob control
Indication of the timer time
Timer control keys
Locking control key
On/o control key for the hob
Stop & Go control key
Power level indication
Bridge function indicator
Timer indicator
Keep warm position indicator
Zone keep warm control key
Zone for slider control rear
Zone for slider control front
Grill function at the location of indication of the power
level
OVERVIEW OF THE FUNCTIONS
Switch hob on/o
Press O/I and hold for 2 seconds. LED will light up.
Press O/I. LED goes out.
Set the power control
MORE - glide your nger over the slider (Power Control)
LESS - glide your nger over the slider to 0
Switching Power on and o
ON - Glide your nger over the slider to the end - [P]
OFF- Glide your nger over the slider [0-9]
Switching Super Power on and o
ON - Switch power on.
Press the end of the slider again
OFF - Glide your nger over the slider [0-9]
Power limit activated
[ 9 ] will be reduced to [8] and ashes [8]
Stop & Go function
ON - Press I I
OFF - Press I I
Locking the controller
On/O - For 6 seconds, press
Select the timer
Press - and + simultaneously on the timer
Reduce the time
press - on the timer
Increase the time
press + on the timer
Switch o the timer function
Press ‐ and + at the same time until the desired hourglass lights up
Keep pressing - on the timer until the timer is at 0
Using the timer without cooking
Switch on the hob. Press - and + simultaneously on the timer Set the
time with - or +.
Programming auto heat up
ON - Glide your nger over the slider, continue pressing on the desired
power for 3 seconds
OFF - Glide your nger over the slider
Keep warm function
Press the
of both front and rear zone simultaneously
Grill function
ON - press the centre of 2 front and rear zone sliders at the same time
OFF - press the 2 front and rear zone sliders at the same time,
then press on the slider under the animated zone
Switch extraction hood on
POSITION 10 cm: Briey press
POSITION 30 cm: For 2 seconds, press
Change extraction hood position
HIGHER - Press
LOWER -
Extraction hood - Run-out function/Switch o
RUN-OUT FUNCTION: For 2 seconds, press
. The extraction
tower will shut o automatically after 10/30 minutes
SWITCH OFF: press
Preset extraction function
Press
1821_110119_GA2.indd 72 19/02/18 23:14