automatically performs a full scan to see what stations are available. You may also
need to start a scan manually to update the list of stations for one of the following
reasons:
o Available stations change from time to time.
o If reception was not good for the original scan, this may result in an empty or
incomplete list of available stations.
o If you have poor reception of some stations (burbling), you may wish to list
only stations with good signal strength.
To start a scan manually, choose Full scan. To scan only stations with good signal
strength, select Local scan.
Once the scan is complete, the radio shows a list of available stations.
To remove stations that are listed but not unavailable, choose Prune invalid.
Turn the navigate reel to view a list of stations and press to select. Once selected, the
station plays and the screen shows information about station, track or show as
broadcast.
5.7.2 Presets
To store a DAB+ preset, press and hold on the remote control until the display
shows the Save preset screen. Select one of the 10 presets to save the current
station.
To select a preset, press briefly, then select one of the listed preset stations.
When a preset station is playing, it shows n ( 1, 2 etc) at the bottom right of
the screen.
“1” to “0” on the remote control are for the use of preset station 1-10.
5.7.3 Now playing information
While the stream is playing, the screen shows its name and DLS (Dynamic Label
Segment) information broadcast by the station giving real-time information such as
programme name, track title and contact details. Stereo broadcasts are indicated
with an icon at the top of the screen. To view further information, press INFO.
Each time you press INFO, another set of information is displayed, cycling through
DLS text, programme type, ensemble name/frequency, signal strength/error rate, bite
To Next Page
Loading...
