NSD VARICAM VS-5F-1 User Manual

56
OPERATION 7. HOW TO USE BASIC FUNCTION
POINT
In the case of selecting the program number from I/O, refer to “8-2. Selection of the Program No. Input Method”.
7-7. Operation
The operation procedure is following:
[1] Selects the switch setting (SET) mode.
[2] Selects the program number to be operated.
[3] Selects the operation (RUN) mode.
[4] Operation (RUN)
VS-5F(-1) doesn’t have any program function, so procedure [1] and [2] is not available.
[ 1 ] Selects the Switch Setting (SET) Mode
① Keeps pressing [MODE] key more than 1 second.
POSITION and MODE display areas are blinking, and
changes to mode selection screen.
② Repeatedly presses [MODE] key, and selects the
switch setting (SET) mode.
③ Presses [SET] key.
Changes to the switch setting (SET) mode.
[ 2 ] Selects the program number to be operated.
Designates the program number by
pressing [+] or [-] key of PROGRAM.
Operation (RUN) mode Switch setting (SET)mode Parametr setting (PRM) mode
SET LED
is ON
LED ON/OFF state
: ON
: OFF
: BLINK
SW-ON LED
is ON
SET LED
is ON
POINT
The password would be already set if "
" is
displayed. Refer to “ APPENDIX 1”.

NSD VARICAM VS-5F-1 Specifications

General

Brand	NSD
Model	VARICAM VS-5F-1
Category	Switch
Language	English