Why am I getting a memory error on my NSD Switch?
If you are getting a 'Memory error' on your NSD Switch, it indicates that the memory data has been altered, possibly due to external noise. To resolve this, perform the initialization operation. Keep in mind that this will reset your parameter and switch output settings, so you'll need to set them up again.
Why does my NSD VARICAM VS-5F Switch show a 'No setting error'?
A 'No setting error' on your NSD Switch occurs when only the ON angle was configured for a switch output, without setting the OFF angle. To fix this, press the [CLR] or [ON / OFF] key to clear the error. Then, make sure to set the OFF angle after resetting the ON angle.
What to do if my NSD VARICAM VS-5F Switch displays a sensor error?
If you are experiencing a sensor error with your NSD Switch, it could be due to several reasons: - The sensor connector might be disconnected or loose. - The sensor cable might be severed. If this is the case, replace the sensor cable. - There may be a failure of the ABSOCODER. In this case, replace the ABSOCODER. - There may be a failure of the VARICAM. In this case, replace the VARICAM. After resolving the cause, clear the error by pressing the [CLR] or [ON / OFF] key, or by inputting the error cancel signal from an external source.
Explains how to read the manual by its purpose.
Lists trademarks of Microsoft, MELSEC, and OMRON.
Outlines safety precautions, signal words, and graphic symbols.
Provides an overview of the VS-5F Series and its benefits.
Guides users on how to select and order the correct model.
Details the technical specifications of the VARICAM unit.
Provides dimensional drawings and measurements for installation.
Covers procedures for handling, installing, and precautions for the VARICAM and ABSOCODER.
Details power supply, VARICAM-ABSOCODER, and connector wiring.
Explains basic operation, panel layout, and setup procedures.
Details how to set and use advanced functions via parameters.
Explains how to configure and manage switch outputs using various methods.
Covers monitoring various states and fine-adjusting outputs during operation.
Describes periodic inspections and criteria for ensuring proper function.
Provides guidance on identifying and resolving errors and malfunctions.
Explains the password function for securing settings and modes.
Details compliance with EMC directives and relevant standards.
Covers installation, power supply, and wiring requirements for UL compliance.
Contains detailed parameter lists and switch output configurations.
To Next Page
General
