Why am I getting a memory error on my NSD VARICAM VS-5FD Switch?
If you are getting a 'Memory error' on your NSD Switch, it indicates that the memory data has been altered, possibly due to external noise. To resolve this, perform the initialization operation. Keep in mind that this will reset your parameter and switch output settings, so you'll need to set them up again.
Why does my NSD VARICAM VS-5FD show a 'No setting error'?
A 'No setting error' on your NSD Switch occurs when only the ON angle was configured for a switch output, without setting the OFF angle. To fix this, press the [CLR] or [ON / OFF] key to clear the error. Then, make sure to set the OFF angle after resetting the ON angle.
What to do if my NSD VARICAM VS-5FD displays a sensor error?
If you are experiencing a sensor error with your NSD Switch, it could be due to several reasons: - The sensor connector might be disconnected or loose. - The sensor cable might be severed. If this is the case, replace the sensor cable. - There may be a failure of the ABSOCODER. In this case, replace the ABSOCODER. - There may be a failure of the VARICAM. In this case, replace the VARICAM. After resolving the cause, clear the error by pressing the [CLR] or [ON / OFF] key, or by inputting the error cancel signal from an external source.
General| Port Speed | 10/100Mbps |
|---|---|
| Jumbo Frame Support | No |
| Model | VS-5FD |
| Ports | 5 |
| Switching Capacity | 1 Gbps |
| MAC Address Table | 1K |
Specifies product usage limitations and compliance requirements.
Provides safety guidelines for handling the unit during operation.
Provides safety guidelines for electrical wiring.
Lists safety measures during product operation.
Details the VARICAM, ABSOCODER, and option model numbers.
Details the technical specifications of the VARICAM unit.
Lists general specifications like power supply, dimensions, and mass.
Details performance aspects like programs, switches, and output cycles.
Outlines the input/output signals and circuits.
Lists the technical specifications for the ABSOCODER sensor.
Provides dimensional drawings and information for the unit.
Shows external dimensions and mounting holes for VARICAM.
Provides dimensional drawings for ABSOCODER models.
Covers procedures for installing the VARICAM and ABSOCODER.
Specifies environmental and physical conditions for VARICAM installation.
Specifies environmental and physical conditions for VARICAM installation.
Details installation conditions and precautions for ABSOCODER.
Explains how to connect the power supply and other components.
Provides instructions for connecting the power supply.
Details the connection procedure between VARICAM and ABSOCODER.
Details the pin arrangement for I/O connectors.
Guides on basic operations and panel functions.
Identifies and explains the control panel components and indicators.
Explains how to configure parameters for basic functions.
Explains how to configure advanced functions using parameters.
Provides a comprehensive list of available parameters.
Details serial communication capabilities and parameters.
Covers advanced functions related to switch outputs.
Explains how to use functions in operation mode.
Explains how to fine-tune switch outputs during operation.
Offers solutions for common errors and problems.
Lists error codes and their corresponding troubleshooting steps.
Lists parameters with their settings and applicable models.
To Next Page
