Why am I getting a memory error on my NSD Switch?
If you are getting a 'Memory error' on your NSD Switch, it indicates that the memory data has been altered, possibly due to external noise. To resolve this, perform the initialization operation. Keep in mind that this will reset your parameter and switch output settings, so you'll need to set them up again.
Why does my NSD VARICAM VS-5F-1 show a 'No setting error'?
A 'No setting error' on your NSD Switch occurs when only the ON angle was configured for a switch output, without setting the OFF angle. To fix this, press the [CLR] or [ON / OFF] key to clear the error. Then, make sure to set the OFF angle after resetting the ON angle.
What to do if my NSD VARICAM VS-5F-1 Switch displays a sensor error?
If you are experiencing a sensor error with your NSD Switch, it could be due to several reasons: - The sensor connector might be disconnected or loose. - The sensor cable might be severed. If this is the case, replace the sensor cable. - There may be a failure of the ABSOCODER. In this case, replace the ABSOCODER. - There may be a failure of the VARICAM. In this case, replace the VARICAM. After resolving the cause, clear the error by pressing the [CLR] or [ON / OFF] key, or by inputting the error cancel signal from an external source.
Essential safety guidelines and precautions to prevent hazards during product operation and handling.
Detailed technical specifications, including electrical, environmental, and performance characteristics.
General and performance specifications for the VARICAM unit, covering power, operating conditions, and features.
Technical specifications for the ABSOCODER position detection sensor, including dimensions and performance.
Guidelines and procedures for the physical installation of the VARICAM and ABSOCODER units.
Instructions for wiring power supply, connecting VARICAM to ABSOCODER, and connector pin assignments.
Recommended installation site conditions, environmental precautions, and mounting cautions for VARICAM and ABSOCODER.
Detailed instructions for connecting the appropriate power supply to the VARICAM unit.
Guidance on how to properly connect the ABSOCODER sensor to the VARICAM unit.
Explains the basic operations of the VARICAM, including panel controls and initial setup procedures.
Details on configuring applied functions using various parameters, including setting methods and parameter lists.
Instructions for setting up and managing switch outputs, including teaching, multi-dog, and arbitrary pulse functions.
Describes how to monitor system status and fine-tune switch outputs during operation in RUN mode.
Identification and explanation of the controls, indicators, and displays on the VARICAM unit's front panel.
Procedure for setting essential parameters, including output specifications, rotation direction, and origin point.
Detailed steps for setting ON and OFF angles for each switch output, including using teaching mode.
Overview of methods for setting numeric values for parameters and basic procedures for parameter configuration.
Procedure to set ON/OFF angles for switch outputs by physically moving the machine and using the TEACH function.
Enables fine-tuning of ON/OFF angles for switch outputs directly during operation, requiring parameter No. 92.
Information on error displays, probable causes, and procedures for resolving common issues with VARICAM and ABSOCODER.
Lists common error codes, their causes, and the steps required to clear errors and restore functionality.
To Next Page
General
