NSD VARICAM VS-5F-1 - 7-6. Sets the Switch Outputs

53
OPERATION 7. HOW TO USE BASIC FUNCTION
POINT
“ ” is displayed on the POSITION display area when data is not designated.
7-6. Sets the Switch Outputs
7-6-1. Selects the Switch Setting (SET) Mode
Keeps to press [MODE] key more than 1 second.
POSITION and MODE display areas are blinking, and
changes to mode selection screen.
Repeats press [MODE] key, and selects the
switch setting (SET) mode.
Presses [SET] key.
Changes to the switch setting (SET) mode.
Operation (RUN) mode Switch setting (SET)mode Parametr setting (PRM) mode
SW-ON LED
is ON
SET LED
is ON
LED ON/OFF state
: ON
: OFF
: BLINK
POINT
The password would be already set if " " is
displayed. Refer to “ APPENDIX 1”.