OPERATION 8. HOW TO USE APPLIED FUNCTIONS (PARAMETER)
8. HOW TO USE APPLIED FUNCTIONS (PARAMETER)
In this chapter, explains applied function that is set by the parameter.
Please use this chapter when needed.
8-1. Parameter Basic Setting Procedure
The parameter is designated by either method after selecting the mode.
(1) Selecting Methods of Numeric Value
This method is applicable with parameters below.
Parameter No.: 03, 04, 77, 78, 81, 82, 84, 85, 89, 91, 92, 93, 94, 95, 97
Refer to “8-1-2. Selecting Methods of Numeric Value” for the operation method.
(2) Inputting the numeric value method
This method is applicable with parameters below.
Parameter No.: 40, 74, 75, 76, 80, 83, 86, 90, 98
Refer to “8-1-3. Inputting the numeric value method” for the operation method.
8-1-1. Selects the Parameter Setting (PRM) Mode
Keeps pressing [MODE] key more than 1 second.
POSITION and MODE display areas are blinking, and
changes to mode selection screen.
Repeatedly presses [MODE] key, and selects the
parameter setting (PRM) mode.
Presses [SET] key.
Changes to the parameter setting (PRM) mode.
Operation (RUN) mode Switch setting (SET)mode Parametr setting (PRM) mode
PRM LED
is ON
POINT
The password would be already set if "
" is
displayed. Refer to “ APPENDIX 1”.
To Next Page
Loading...
Need help?
General
