APPENDIX APPENDIX 1. PASSWORD FUNCTION
POINT
*1: The password setting range is “001” to “999”.
*2: Input the “000” in the procedure ⑦ and ⑨ if the password function is cancelled.
Inputs the current password.
Presses [+] or [-] key of POSITION once,
“000” is blinking in the POSITION display area.
Go to the procedure ⑥ after the above-procedure
when setting the password for the first time.
In the case of changing the password,
input the password which is already set
by pressing [+] or [-] key of POSITION again.
If [CLR] key is pressed in this timing, returns to
the mode which is just before inputting the password.
Enters the current password.
Presses [SET] key.
Displays the new password input screen.
Inputs the new password.(1st)*1*2
Inputs the new password by pressing
[+] or [-] key of POSITION.
If [CLR] key is pressed in this timing, returns to
the mode which is just before inputting the password.
Enters the new password.
Presses [SET] key.
Displays the password input screen for the confirmation.
Inputs the password for the confirmation. (2nd)*1*2
Inputs the new password by pressing
[+] or [-] key of POSITION again.
If [CLR] key is pressed in this timing, returns to
the mode which is just before inputting the password.
Enters the password for the confirmation.
Presses [SET] key.
- The operation tone beeps when the password is completely set. The mode returns just before setting the
password.
- If the password is different between (1st) and (2nd), the operation tone would beep out three times.
In this case, the new password input screen is displayed, so operate from the procedure ⑦ again.
New password input screen
Password input screen for a confirmation
To Next Page
Loading...
