OPERATION 7. HOW TO USE BASIC FUNCTION
[ 3 ] Selects the Operation (RUN) Mode
Selects the operation (RUN) mode, refer to the procedure [1].
[ 4 ] Operation (RUN)
The switch output turns ON or OFF according to the setting value during the operation.
Indicates the monitor contents during the operation.
Name Descriptions
①
RUN LED is ON: Indicates the operation (RUN) mode.
② PROGRAM display
Displays selecting the program number.
(VS-5F and VS-5F-1 are not available this function.)
③ SW / PRM display Displays the switch number which is selected by SW /PRM key.
④
If there is no error, this indicator will turn ON when selecting operation (RUN) mode.
This indicator is same condition as “System ready output signal” of the output connector.
⑤ DOG display Monitors the switch number output state that is selected by SW / PRM key.
ON : OFF :
⑥
Displays the current position value.
⑦
Selects the switch number that is monitored on DOG display area.
①
②
③
④
⑤
⑥
⑦
To Next Page
Loading...
Need help?
General
