15
Cleaning / Lubrication / Checking of the Attachment, Slim Attachment Hub and Slim Tube
English
_ Pre-cleaning
1
Remove contaminants on the surface with a cloth or soft bristle brush under running tap water.
For products with moving parts, perform cleaning while moving all parts (see “2 Moving Parts of Each Product”).
≤ 38°C, ≥ 3.5 L/min, ≥ 30 sec.
Water quality: Drinking water
2
Turn the Twist Collet to the closed position (if applicable).
3
Mount the Cleaning Adaptor.
Pull the Cleaning Adaptor to make sure that it is securely
connected.
4
Assemble the product as shown in the figure.
Pull each connection part to make sure that it is securely connected.
* If the Cleaning Tube is deteriorated, replace it with a new one.
To Next Page
Loading...
