NSK VarioSurg 3 - Tube Holder Attachment

English
11
5-7 Connection of the Tube Holder
Push the Tube Holder on to the Handpiece Cord, then push the
Irrigation Tube into the Tube Holder.
CAUTION
CAUTION
ŘAlways use a Pack with a sufficient quantity of saline.
ŘBefore opening the Tube Clamp, always close the Pump Cover. If the Tube Clamp is opened while the
Pump Cover is open, saline will flow out of the Irrigation Tube Tip.
ŘWhen the coolant solution runs short, stop using the system and replace the Coolant Solution Pack.
ŘBe sure to check that the coolant solution is flowing properly before using the system again.
ŘBundle the Handpiece Cord and the Irrigation Tube at a
total of 7 locations.
Fig. 14
Fig. 13
Irrigation Tube
Tube Holder
Handpiece Cord
9DULR6XUJ(1LQGG 