Nu-Tek Levator Elite LE9011 User Manual

- Page 39 -
Nu-Tek Levator Elite User Manual
Mains power quality should be
that of a typical commercial or
hospital environment. If the
user of the device requires
continued operation during
power mains interruptions, it is
needed that the device be
powered from an
uninterruptible power supply.
Power frequency Magnetic elds
should be at levels characteristic
of atypical location in a typical
commercial or hospital
environment.
NOTE: U
T
is the a.c. mains voltage prior to application of the test level.
Voltage dips,
short
interruptions and
voltage
variations on
power supply
input lines
IEC 61000-4-11
Power
frequency
(50/60 Hz)
magnetic eld
IEC 61000-4-8
<5% U
T
(>95%
dip in U
T
) for
0.5 cycle 40%
UT (60% dip in
U
T
) for 5 cycles
70% U
T
(30%
dip in U
T
) for
25 cycles <5%
U
T
(>95% dip in
U
T
) for 5
seconds
3 A/m 3 A/m
Not Applicable
- Battery
Operated
Device
Guidance and manufacturer’s declaration - electromagnetic immunity
Immunity test
IEC 60501 test
level
Compliance
level
Recommended separation
distance
Electromagnetic
environment - guidance
The Nu-Tek Levator Elite is intended for use in the electromagnetic environment
specied below. The customer or the user of the device should assure that it is used
in such an environment.
Portable and mobile RF
communications equipment
should be used no closer to any
part of the device, including
cables, than the recommended
separation distance calculated
from the equation applicable to
the frequency of the transmitter.
Table 3
Operated
Device
hospital environment.

Nu-Tek Levator Elite LE9011 Specifications

General

Brand	Nu-Tek
Model	Levator Elite LE9011
Category	Medical Equipment
Language	English