Nuga N6 - Post-Installation Testing; Power Supply Verification; Controller Functionality Check; Auxiliary Heating Part Test

N6
Descriptions for Controller Buttons
Display setup
How to Use the Controller
How to Use the Product by Mode
Temperature setting for the Auxiliary heating part
How to Use the Low Frequency Pad
How to Use the External projector(Abdomen heating pad)
Preheating function
Sleep music
How to Use the Product
20
21
22
32
22
25
26
28
29
30
How to Use the Product
Test Operations after Installation
Check out the power
supply for the product
Turn on the power switch.
1
2
Check out operation of the
Auxiliary heating part
Press the star ( ) button on the
controller and set the temperature by
pressing ▲or ▼.
3
Use the product
Lie down with your legs facing the
auxiliary body and press “AUTO” on the
controller to operate the device in
automatic mode.
4
Caution
Ensure the power supply to be
turned off after use or during no use.
Otherwise, it might cause failure.
18
N6
Power switch
in the main assembly
Off
On
Check out operations of
controller
① Press the power button on the
controller ( )
② Adjust temperature for the internal
projector ( )
③ Adjust temperature for the external
projector(Abdomen heating pad)
( )
Refer to ‘How to Use the Controller’
by mode (Page 22)
①
②
③