How to Install the Product
Product installation
① Remove the band and raise the device
vertically with the controller on top.
② Press the lever for the legs and unfold
the legs..
③ Raise the main part of the device
upright and open up the auxiliary part.
④ Press the hinge on the controller and
rotate it 90°
(The length can be adjusted for your
convenience.)
Transporting the device
Transport the device using the
installed wheels.
1
2
16
N6
17
Caution
Make sure the controller is facing
up.
(It may cause controller damage or
failure.)
To avoid injury by tipping over, set
the product to the following tilted
position before moving.
①
②
③
④
Leg lever
Controller hinge
Production Installation and Use
Caution
Caution
More than 10℃
Turn on the power supply
in the product
Connect the power cable to the body as
shown in the figure and turn on the
power switch.
3
Turn off the power switch when the
power is connected.
Otherwise, it might cause failure.
Turning on the controller
Press the button to turn on the
power and use the device.
(Refer to “How to use the controller”
for more details)
4
⑤ If the product is out of height, place
the height adjustment rubber under
the leg which is near the head or
waist part to adjust.
Notice
If you use more than 2, use after
adjusting to the hole.
⑤
i
To Next Page
Loading...
