Check Indicator Window of Controller
How to Take Emergency
Actions during Use
Stop using the product immediately and remove the
power plug if there is any lightning.
Use the low-frequency pad tower after cleaning when
it has been used 2~3 times.
Use the outer cloth after cleaning when it has been used
about 10 times.
Stop using the product immediately and consult with a
doctor if any abnormality occurs from the human body.
Turn off the power switch immediately, stop using the
product and contact our company if you find out any
failure or power failure from the product.
Stop using the product immediately and contact your
supplier branch or our company if you smell any burn or
detect any smoke from the product.
Turn off the power switch, remove the power plug
immediately, and then contact our company if you have
poured water into the product.
Anyone other than technicians qualified for our company’s
A/S shall not disassemble, repair or modify the product
by any means. No modification of this equipment is
allowed.
(Otherwise, it might cause damage to the product
or electric shock and/or fire.)
36
N6
37Product Storage and Care
Mandatory action
Caution
Do not disassemble the product arbitrarily if any error occurs, but remove the
power plug, turn off the power switch, and then contact your supplier.
If you disassemble the product arbitrarily, it might cause serious injuries
and/or damage to the product.
Display
Internal Projector
Auxiliary heating
part
External projector
(abdomen
heating pad)
Error code
E0
Lumbar vertebrae
:Abnormal temperature sensor
Thoracic vertebrae
:Abnormal temperature sensor
Cervical vertebrae
:Abnormal temperature sensor
Thoracic vertebrae
:Heater bar disconnection
Cervical vertebrae
:Heater bar disconnection
Overheating of the internal
projector
Abnormal Limit sensor
Abnormal Motor
Abnormal Controller
communication
Lumbar vertebrae
:Heater bar disconnection
Abnormal temperature sensor behavior in the main
heating part
Disconnection in the main heating part
Abnormal temperature sensor behavior in the lower
heating part
Disconnection in the lower heating part
Overheating of the element
Disconnection in the temperature sensor of the external
projector(abdomen heating pad) (not connected)
Abnormal temperature sensor behavior of the external
projector(abdomen heating pad)
Disconnection in the lamp
of the external projector(abdomen heating pad)
Overheating of the external projector(abdomen heating pad)
E1
E2
E3
E4
E5
E6
E7
E8
E9
E0
E1
E2
E3
E6
E1
E0
E6
- -
Check Indicator Window of Controller
To Next Page
Loading...
