12
www.numatic.co.uk
After use, empty waste water tank using emptying hose and ush-out with
clean water.
Remove oor tool vacuum hose ensuring you remove the U-bend clip and ush out
with clean water.
Empty clean water tank, using emptying hose and again ush out with clean water.
Machine cleaning
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY MAINTENANCE.
!!
Push in the 2 retaining handles of the separator.
Remove and clean vacuum shut o lter. Remove large debris lter, clean and replace. After cleaning, ret the separator and reconnect
the hoses.
Holding the handles lift the separator away. Clean and examine rubber seal during
each clean.
Located in your waste water top tank is a vacuum shut o system, this prevents suction when the waste water tank is full.
It also prevents foam created by high-foaming detergents from entering the motor.
Sometimes the oat vents get clogged and blocked, clean to ensure correct operation. Remove debris basket lter and rinse using
clean water, and ret.
Ret both of the vacuum hoses.
IMPORTANT: IF THE DEBRIS BASKET IS ALLOWED TO BECOME CLOGGED,
VACUUM PERFORMANCE CAN DETERIORATE.
!!
To Next Page
Loading...
Need help?
General