Machine set-up guide
7
T (+ 44) 01460 68600
Fitting the side pod skirts
To t the side pod skirts, rst remove the steel retaining strip already tted to the pod (Fig.1).
Align the steel retaining strip within the locating grooves of the rubber skirt and ret using existing screws (Fig.2).
Periodically the side skirts should be examined and checked for wear and damage. Replace as shown above.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
!!
Pull the side pod lever and set to the top position (Fig.1). The side
pod will now pull open.
Slide brush under the chuck and raise into place, turn the brush
anti-clockwise to locate and lock into position. Repeat the
process with the second brush on the opposite side. Close side
pod and move pod lever back into the locked position.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS.
!!
!
Fitting the brush
Brush location
SAFETY GLOVES ARE RECOMMENDED FOR
THE CHANGING OF USED BRUSHES.
To Next Page
Loading...
Need help?
General