Machine set-up guide
5
T (+ 44) 01460 68600
Use handle grip when
raising or lowering the
top waste tank.
Fuses
●
Owner manual
●
Battery charging lead
● 2 x 40 Amp fuses (200T) /
3 x 40 Amp fuses (300T)
● 30 Amp fuse ● 20 Amp fuse
● 4 Amp fuse ● 2.5 Amp fuse
●
Maxi fuse-puller
●
2 x Keys
Lift top tank assembly to reveal battery
compartment, ensuring you use the handle
grip provided.
Fit battery fuses (contained in start-up pack)
into the battery fuse holder as illustrated.
Insert key into ignition located on the
control panel.
NOTE: Wear suitable gloves when
inserting fuses.
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
!!
Lift fuse cover and Insert battery fuses. Switch on the machine. Remove the key when
the appliance is not in use.
Battery display panel illuminates to show power.
Set direction switch to forward. Set to slowest speed, depress accelerator and
drive o the pallet using ramp provided.
Once in a safe location switch o machine.
Less battery models - Numatic International Ltd recommends using MK Batteries for the TRG machines mentioned in this manual.
For full battery specications see page 24.
!
!
NOTE: DO NOT DEPRESS ACCELERATOR PEDAL WHILE SOFTWARE INITIALISES. The machine will not operate in reverse
with the oor tool lowered. The seat is tted with a pressure sensor that disables the machine until an operator is seated.
To Next Page
Loading...
Need help?
General