16
www.numatic.co.uk
Machine charging
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO CHARGING.
!!
Machine charging point, above footplate. Insert country specic charging lead. Red charging indicator illuminates when charging.
1. The battery meter displays the charge level of the batteries;
when fully charged, all meter lights are illuminated.
2. As the machine is used and the batteries are discharged,
the meter lights will go out from right to left.
3. When the battery meter turns RED the vacuum motor and the brush motor will stop. Once the motors have stopped, turn o the
vacuum motor and lift the brush deck. Turn the key o then back on. If required switch the vacuum motor on to pick up any remaining
liquid. Take machine to charging location and place on charge. Ensure the vacuum motor is switched o and the machine is turned o
by the key before charging.
Insert the charging lead required for your country into the charging point.
The machine charging point is located to the rear of the machine under the control panel.
Connect to a suitable power supply.
Once mains power is connected the red charging indicator will illuminate.
To ensure a full charge, the machine should be left for a period of 8 - 10 hrs.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
The large capacity gel batteries are sealed for life and are totally maintenance free.
The on-board charger automatically monitors the charging process and will switch o when
the batteries are fully charged.
NOTE: The charging lead supplied with your machine may dier than the lead shown.
Once the charging lead has been connected the machine will be INHIBITED.
The battery charge indicator display lights will show the current charge state.
To ensure a full charge, the machine should be left until the charging indicator shows green.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
Charging indicator (see page 17)
External charging point
ALWAYS ENSURE THE MACHINE IS
SWITCHED OFF PRIOR TO CHARGING.
Recharge batteries after each use,
regardless of machine operation time.
The machine charging point is located under
the top tank in the centre of the machine.
Remove Isolator Plug (1) and connect your
external charger (2).
Ret Isolator Plug before operating the
machine.
NOTE: ONLY USE THE RECOMMENDED CHARGER AND LEADS. CONTACT NUMATIC INTERNATIONAL LTD
FOR RECOMMENDED CHARGER AND LEADS.
!!
To Next Page
Loading...
Need help?
General