Numatic TRG 720/200T User Manual

Machine set-up guide
8
www.numatic.co.uk
Fill level indicator
Raise brush deck / Lower brush deck
1
2
3
A
After preparing the oor, we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
While depressing left-hand foot pedal (1), press down the release lever (2) and gently release the foot pedal to lower the brush deck (3).
Filling the clean water tank
The TRG 720 is equipped with a large capacity 120 litre clean water tank allowing for large areas to be covered in a single ll.
To ll the clean water tank, lift the cover ap (Fig.1) to expose the
ller cap.
Unscrew the ller cap (Fig.2) and ll the tank using a hose (Fig.3)
or preferred method. Add cleaning chemical to the tank following
the manufactures guidelines.
Note: A lter basket ensures that contaminants (i.e. leaves,
hair, dirt, etc.) are not allowed to enter the clean water tank
during the lling process. Periodically inspect and clean if
necessary.
The water level in the clean water tank can be measured using the
visible red oat inside the clean water dump hose on the rear of
the machine.
Do not overll the clean water tank.
1
2
A
3
Fill-level indicator
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS.
!!

Numatic TRG 720/200T Specifications

General

Brand	Numatic
Model	TRG 720/200T
Category	Scrubber
Language	English