11
Filling the clean-water tank
The TTB Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaned in a single ll.
To ll the clean-water tank, use the FLEXI - FILL
pipe from either a tap or hose pipe (Fig.21).
The large cap can also be used for lling from a
bucket or suitable container.
Fill the clean-water tank to a maximum of 40 litres,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
Note:
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc)
are not allowed to enter the clean-water tank during the lling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Machine Set-Up
The clear Dump hose at the rear of the machine
can be used to see the level of the clean water.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specication.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/ for UK information.
Fig.21
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
!
!
Pre-cleaning advice
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the
oor (Fig.22).
Numatic part (629044) Wet Floor sign
(available if required)
Fig.22
MAX
To Next Page
Loading...
Need help?
General