8
Using the handle position lever
(Fig.1), move the handle into the
upright position (Fig.2).
PLEASE READ BEFORE COMMENCING ANY OPERATION.
After the removal of all the packaging, carefully open and check the contents.
Ensure the Batteries are charged before use.
! !
Fit the isolator key and switch the machine on (Fig.7).
Quick Set-Up Guide
Place 50 amp fuse (supplied in the accessory kit)
into the fuse holder using the Maxi Fuse puller
provided (Fig.3).
(Fig.4) Shows 50 amp fuse.
Place the top tank (waste water) onto the machine (Fig.5) and connect the
vacuum and oor-tool hose to the separator (Fig.6).
Fill the bottom tank (Clean Water) from a tap or hose pipe using the Flexi-Fill
pipe (Fig.8) or remove the ller cap from the rear left of the machine and ll
using a bucket (Fig.9). Add non-foaming cleaning uid as required
(See page 11). The TTB 4045 / TTB 4055 / TTB 4552 all have a water
capacity of 40 Litres.
Fig.2
Fig.4
Fig.6
Fig.8
Fig.9
Note:
Great care must be taken to ensure that
contaminants (leaves, hair, dirt, etc.) are not
allowed to enter the clean-water tank during the
lling process.
If using a bucket or similar, ensure it is always
clean and free from debris.
Fig.1
Fig.5
Fig.7
Fig.3
50Amp
To Next Page
Loading...
Need help?
General