13
Brush overload
The brush motor will cut out and the brush load light will ash
if the brush motor has been overloaded (Fig.28).
Releasing the handle triggers will allow the machine to stop
and reset.
If the brush motor keeps overloading consider using a different type of brush.
Or move the transit wheels to obtain different brush pressures,
Heavy brush load decreases the available battery run time.
Setting the cleaning controls
The water and vacuum function can be activated or
de-activated when your machine is running i.e. active.
Cleaning mode select low and off aisle can only be selected
when in Stand-by mode.
Fig.28
To activate the machine from SLEEP MODE
press either on / off trigger or yellow on / off switch
once.
The sleep mode will re-activate after 60 seconds if no
further controls are used.
Stand-by mode will be entered and will illuminate blue
display lights.
When the on / off triggers are released the brush motor and the cleaning solution pump will switch off, the vacuum motor will
continue for 10 seconds (this is to clear any uid residue in the hose).
The panel if unused will automatically enter SLEEP MODE after 60 seconds.
The TTB has been tted with a Hi - Lo mode, this reduces the noise produced by the vacuum motor.
Hi - Lo is only selectable when the machine is in stand-by mode.
When the machine is running Hi mode the Hi - Lo indicator will be illuminated blue, this means the Vacuum
motor is running at 100%
When the machine is in Lo mode and the Hi - Lo indicator is NOT illuminated the Vacuum motor will run at
75% of its capacity.
Fig.27
To Next Page
Loading...
Need help?
General