14
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
! !
Remove the two hoses to disconnect the separator from the
machine (Fig.30).
Lift off the separator. The separator has a sealing-rubber which
should be examined at every clean-down (Fig.31).
Rinse using clean water.
Remove the lter tted into the separator and ush with clean water (Fig.32) (Fig.33).
Placed into the top tank is grey lter basket, clean and ush with clean water (Fig.34) (Fig.35).
Regular Maintenance
The Bottom (Clean Water) tank is attached to the chassis and should only
be removed by a competent service engineer (Fig.36).
Clean by ushing with clean water if required.
Excess water can be drained using the clear dump hose tted to the rear
of the machine.
Located under the left hand side is a clean water lter, ensure the clean
water tap is turned off before removing this lter (Fig.37).
Clean and ush with clean water if required.
Fig.29
Fig.31
Fig.32
Fig.33
Fig.36
Fig.37
Fig.34
Fig.35
Fig.30
Fig.37
The TTB Range has been designed with ease of use in mind, this included easy
stripping-down and cleaning. After use, empty waste-water tank using emptying
hose and ush out with clean water (Fig.29).
To Next Page
Loading...
Need help?
General