21
21
EN
NOTE:
Fitting the Floor-Tool
Machine Set-up Guide
the machine. (Fig.1).
Secure to the carrier using the two knobs
(Fig.2) - (Fig.3).
Do not over tighten the retaining knobs.
Ensure inspection cap is in place on the
(See Page 56).
400mm Brush / 360mm Pad.
Featuring the Nulock brush system.
Slide the brush / pad under the brush deck.
Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place.
Turn on the clean water tap.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
!
!
To Next Page
Loading...
