19
Next remove oor-tool vacuum hose and ush-out
with clean water.
Next empty clean water tank, using emptying hose
and again ush-out with clean water.
Regular Maintenance
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
!
!
After use, empty waste-water tank using emptying
hose and ush-out with clean water.
A
A
B
C
B
C
Whilst pressing in the top tank hood toggles, remove the hood (Fig 38)
The hood also has a sealing-rubber which should be examined at
every clean-down.
Rinse using clean water , avoiding the vac lter
IMPORTANT:
Remove white vac lter and clean if required (keep dry) (Fig 39).
Never use the machine without the recommended lter as it may cause damage to the vac
motor.
Remove debris basket lter and rinse using clean water, and ret.
IMPORTANT:
If the debris basket is allowed to become clogged, vacuum performance can deteriorate.
(Fig 40)
The clean-water tank lter is located to the rear of the battery compartment,
and should be checked at regular intervals.
Unscrew the cap check the lter condition (Fig 41), rinse and ret.
Ensure tank has been emptied and care is taken when working in the vicinity of
batteries.
Fig.41
Fig.38
Fig.39
Fig.40
NOTE:
ANY SPILLS SHOULD BE WIPED-UP BEFORE THE TOP TANK IS
LOWERED.
To Next Page
Loading...
Need help?
General