6002 addressable control and indicating equipment
User Manual
3
33-0019-r04_2018-08
© 2017, 2018 Ambest Electronics (Ningbo) Co Ltd. All rights reserved.
All specifications and other information were current at the date of publication and subject to change without notice.
QUEUE REVIEW
FIRE LED will flash if more than one input device is reporting a fire. Pressing the button
will step through the queue of fire events. Once the queue has been reviewed, the
LED will be on steady. If a new event occurs, the LED will begin to flash. An event
in the queue will be displayed for 20 s, after which time the LCD will display the
first alarm event.
FAULT LED will flash if more than one input device is reporting a fault, or if a fire signal is
also present when a fault occurs. Pressing the button will step through the queue
of fault events. Once the queue has been reviewed, the LED will be on steady. If a
new event occurs, the LED will begin to flash. An event in the queue will be
displayed for 15 s. After this time, the LCD will display the first fault event, or the
fire event if a Fire Condition exists.
TEST LED is on during the Test Condition. Pressing the TEST button will display which
detection zones and which alarm zones are in Test. If the LCD cannot display all
zones, pressing the TEST button again will display the next page of results. A test
event will be displayed for 15 s, after which time the LCD will revert to the default
display.
DISABLE
LED will be on if one or more devices are disabled. Pressing the DISABLED
button will step through the queue of disablements. An event in the queue will be
displayed for 15 s, after which time the LCD will revert to the default display.
DISABLEMENTS
SELECTED
DEVICES
Selects specific input devices (detectors, manual call points, input/output
modules) for disablement/enablement. Used in conjunction with KEYPAD and
LCD. The indicator is active when disablements are active.
ALARMS Disables and enables alarm output devices. When the indicator is active, the
alarm devices are disabled.
ALARM RELAY
Disables and enables on-board Alarm Condition relay outputs. When the
indicator is active, the output relays are disabled.
FAULT RELAY Disables and enables on-board Fault Condition relay output. When the indicator is
active, the output devices are disabled.
To Next Page
Loading...