Nuna mixx2 User Manual

2524
EN EN
2
1
3
Accessories
Nuna PIPA
Infant Car Seat Adapters
WARNING
• Avoid serious injury from child falling out. Always secure
child in the infant car seat harness as explained in your
infant car seat manual before attaching the infant car seat
to the stroller.
• NEVER place infant car seat in the stroller seat.
• ONLY USE THE NUNA PIPA INFANT CAR SEAT with
this stroller. NEVER use other manufacturer’s infant car
seats with this stroller unless approved by the manufacturer.
• ONLY install your PIPA infant car seat REAR-FACING
on the adapters.
When using your Nuna PIPA infant car seat, please
follow these instructions:
REMOVE STROLLER SEAT FROM FRAME IF ATTACHED.
1 - To attach adapters, insert adapters onto mounts until
they click into place. PULL UP on adapters to make
sure they are securely attached.
2 - Line up the infant car seat handle hubs with the
adapters as shown.
3 - Insert the infant car seat into the adapters until it
CLICKS into place. PULL UP on the infant car seat to
make sure that it is securely attached into the adapters.
hub

Nuna mixx2 Specifications

General

Weight Capacity	50 lbs
Recline Positions	5
Harness Type	5-point
Wheel Type	All-terrain
Seat Recline Positions	5
Seat Facing Directions	Forward and Parent-facing
Suspension	All-wheel suspension
Frame Material	Aluminum
Brake Type	One-touch, rear wheel
Stroller Height	44.3 inches
Stroller Width	23.5 inches
Folded Width	23.5 inches
Seat Width	12 inches (30.5 cm)
Seat Depth	9 inches (23 cm)
Canopy	Extendable UPF 50+ canopy with flip out eyeshade
Front Wheel Size	7.5 inches
Brakes	One-touch, rear wheel
Compatible Car Seats	Nuna PIPA series
Fabric Material	Polyester