Nuna mixx2 User Manual

1312
EN EN
Opening the MIXX
2
Before setting up the stroller, atten the carton and place it
on the oor.
1 - Open the storage latch as shown.
2 - Rotate the handle (1) to the rear of the stroller until it
clicks into the open position.
Squeeze the handle
(2) on the back of the seat and
rotate the backrest to the upright position.
CHECK that the stroller is completely latched open before
continuing.
Assembling the Canopy
3 - Line up the canopy visor zipper with the zipper on the
inside ofthe front edge of canopy. Completely zip the
canopy visor onto the front of canopy.
4 - Insert the canopy clips into the canopy mounts on the
sides of the stroller until they click into place.
Assembling the Front Wheels
5 - Push wheels onto the front leg tubes until they click
into place.
CHECK that wheels are securely attached by
pulling down.
6 - To remove front wheels, press the button and pull
wheel down.
2
1
3
4
6
5
1
2

Nuna mixx2 Specifications

General

Weight Capacity	50 lbs
Recline Positions	5
Harness Type	5-point
Wheel Type	All-terrain
Seat Recline Positions	5
Seat Facing Directions	Forward and Parent-facing
Suspension	All-wheel suspension
Frame Material	Aluminum
Brake Type	One-touch, rear wheel
Stroller Height	44.3 inches
Stroller Width	23.5 inches
Folded Width	23.5 inches
Seat Width	12 inches (30.5 cm)
Seat Depth	9 inches (23 cm)
Canopy	Extendable UPF 50+ canopy with flip out eyeshade
Front Wheel Size	7.5 inches
Brakes	One-touch, rear wheel
Compatible Car Seats	Nuna PIPA series
Fabric Material	Polyester