Nuna mixx2 User Manual

1514
EN EN
Assembling the
Rear Wheels and Storage Basket
1 - MAKE SURE the brake lever is facing up before
attaching to frame.
Push brake assembly onto the rear
leg tubes until it clicks into place.
CHECK that brake assembly is securely attached by
pulling on it.
2 - Line up the tab on the wheel axle with the groove in
the brake assembly and push rear wheel onto the
brake assembly until it clicks into place. Repeat with
the other wheel on other side of brake assembly.
CHECK that wheels are securely attached by pulling
down.
3 - To remove rear wheel, press the button (1) and pull
wheel off
(2) of brake assembly.
4 - Wrap the basket ap around the rear frame tube and
fasten the 3 snaps.
Assembling the Armbar
WARNING Always secure the child
with the harness. The armbar is not a restraint device.
5 - To attach armbar, insert the armbar into channels on
both sides of the seating area.
6 - To remove, push the buttons on the outside of the
stroller as shown.
7 - Fasten the inner snaps of the seat pad to the inside of
the seating area as shown.
Stroller set up is complete.
2
1 4
3 7
5
6
brake
lever
tab
groove
1
2

Nuna mixx2 Specifications

General

Weight Capacity	50 lbs
Recline Positions	5
Harness Type	5-point
Wheel Type	All-terrain
Seat Recline Positions	5
Seat Facing Directions	Forward and Parent-facing
Suspension	All-wheel suspension
Frame Material	Aluminum
Brake Type	One-touch, rear wheel
Stroller Height	44.3 inches
Stroller Width	23.5 inches
Folded Width	23.5 inches
Seat Width	12 inches (30.5 cm)
Seat Depth	9 inches (23 cm)
Canopy	Extendable UPF 50+ canopy with flip out eyeshade
Front Wheel Size	7.5 inches
Brakes	One-touch, rear wheel
Compatible Car Seats	Nuna PIPA series
Fabric Material	Polyester