Nussbaum 2.35 TSK - How Often Must the Lift be Cleaned

Operating Instruction and Documentation
2.35 TSK
- 22 -
Use an ATF-Suffix hydraulic-oil (OEST Company ) if the ambient temperature is under 5
degrees centigrade. After filling, the hydraulic oil must be between the upper and lower
markings of the oil level gauge.
Remove the old oil according to the appropriate regulations.
• Check all welded joints for cracks on the automotive-lift.
If any cracks are found on the lift cease use immediately. Switch-off and secure the main
switch (lock) and call the service partner.
• Ensure that the rubber plates of the lifting arms remain in good condition.
• Check the condition and the function of the locking system of the arms. In case of damages
of the teeth and the locking system, necessarily exchange it.
• Check all surfaces and repair if necessary.
• Damage to external surfaces, must be immediately repaired.
If theses repairs are not made immediately, permanent damage to the powder-coated
surface may result.
Repair and clean damaged areas with an abrasive paper (grain 120). After this is complete,
use a suitable paint (observe the RAL Number).
• Check the zinc surface and repair it with a suitable tool. Use abrasive paper (grain 280).
White rust can result from moisture laying in certain areas for long periods of time. Poor
aerating can also result in rust formation.
Rust may result from mechanical damage, wear, aggressive sediments (de-icing salt, liquids)
or insufficient cleaning.
Repair and clean these areas with abrasive paper (grain 280).
After this is complete, use a suitable paint (observe the RAL Number).
• Check all the safety devices of the lift.
• Check the electric cable and channels for Damage.
• Check that all screws and bolts are correctly torque (turning moments, see the list)
Pic 10:
7.2 How often must the lift be cleaned?
A regular and appropriate maintenance practice will aid the preservation of the lift.
No guarantees can be given when damage (egg rust or fading colour) is the direct result of poor
maintenance and cleaning practice.
Regular cleaning of all kinds of dirt is the best protection against wear and the formation of rust
and will prolong the life of the lift
- Dirty deposits that can cause rust include:
• de-icing salt
• sand, pebble stone, natural soil
• all types of industrial dust
• water; also in connection with other environmental influences
• all types of aggressive deposits
• constant humidity caused by insufficient ventilation